N O T I C E This answer illustrates the importance of proper signal input, gain setting, crossover configuration & speaker impedance with any Rockford Fosgate amplifier. For specific setup and wiring configurations, please refer to your owner's manual. Stereo Mode - The diagram below illustrates how to configure most Rockford Fosgate 2-channel amplifiers for stereo mode. • • Signal Input - Your amplifier may have either Hi-Level or Low-Level inputs.
Hi-Level inputs are used when the source unit only has speaker line outputs. Shiru Wa Gp Agiginyani Mp3. Low-Level inputs are used when the source unit has preamp line (RCA) outputs. Use only one method when connecting an input signal to the amplifier. • Gain Control - The input gains for left and right channels operate independently, however these usually do not need adjustment from the factory. If they have been re-adjusted for some reason, you can manually rest them by using the following procedure: With the system turned on. Tutorial Belajar Bahasa Arab Pdf Printer.
2017-09-04 weekly 2017-09-04. 2017-09-04 weekly. Rockford Fosgate Fnx-2614 6. Product Information: General. Diesel Generator - 7250 Watt - All Service And Owner Manuals Included - Full 1 Year Or 1000 Hour Warranty St. Vodka'golden Reshka'has A Unique Recipe Which Combines Clear,pure Natural Water From Elbrus Mountaines,high.
1) Turn the amp's gain controls to minimum. 2) Turn the source unit to 3/4 volume. 3) Slowly increase both L/R gain controls until the system is at its maximum listening level. 4) You're done! • Crossovers - Your amplifier may utilize an internal crossover. If so, the crossover can be set to High-Pass (HP) for use with midrange speakers & coaxials; Low-Pass (LP) for use with subwoofers; or Full Range (FULL) for use with component systems. • Speaker Impedance - most Rockford Fosgate amplifiers can operate at 2-Ohms or 4-Ohms per channel.
It is important that you do not connect a speaker system to your amplifier that results in an impedance lower than the minimum recommended for your amplifier. Mono (Bridged) Mode - The diagram below illustrates how to configure most Rockford Fosgate 2-channel amplifiers for mono mode. • • Signal Input - Your amplifier may have either Hi-Level or Low-Level inputs. Hi-Level inputs are used when the source unit only has speaker line outputs.
Microxp Micro Xp Pro 0 986. Low-Level inputs are used when the source unit has preamp line (RCA) outputs. Use only one method when connecting an input signal to the amplifier. When using the RCA inputs, both inputs must be utilized.
If your source unit or signal processor only provides one (1) sub-level pre-out, use a 'Y-adapter' to convert the (1) RCA feed into (2) RCA inputs. • Gain Control - The input gains for left and right channels need to be set to the same level when operating in Mono (Bridged) Mode. These usually do not need adjustment from the factory. However if, for some reason, you need to manually reset them, use the method above described in Stereo Mode. • Crossovers - Your amplifier may utilize an internal crossover.